Originally posted by TCLynx on AGC, Nov 6, 2010
Raft Bed Saga Part 2
This day in November, to be plumbing wet liner and splashing in water.
But once a project thus started, it must be completed, unless paying work is what is competing.
I’m sorry my poetry may not be compelling but here are some pictures to quell your misgivings.
Last night I did fill the liner with water to see what would happen.
Come morning I found that the bed was a bowing, To solve this dilemma I did add some wire
Then on to the plumbing for which it was chilly, I’m known to attempt this between pump cycles and spraying.
Once this was accomplished then on to re-filling, the bed it is online, the outcome is pending.
Now on with my raft experiment next to appear, should be some creative raft ideas hopefully near.
I did get a sheet of 3/4″ blue board, the lowes did not have any 2″ I fear.
This cut in 3rds will cover from sun while I play with other materials I can forage for fun.
Note the wire stays across the top of the bed holding it in from collapse and utter dread.
Then the other wire arch of the same material will be repeated down the bed to support the debris shed.
My hope with wire supports that cloths pins old fashion will surfice to hole the frost blanket and keep out the leaves.
So on to ideas for plant supporting means, perhaps a square of sealed PVC will make waves
What should go with this I’m in need of some names.
And for those that may have missed the beginning of this saga, here is the link to get you caught up.
http://aquaponicscommunity.com/profiles/blogs/uh-oh-i-have-another-bit-of
Leave a Reply